We are pleased to announce the availability of our new windshield adapter specifically designed for the new Honda NC700X & NC750X. The kit repositions the standard screen slightly further away from the bike which also raises the screen by approximately 50mm (in its lowest setting), thereby optimizing its performance.
It also offers a tilt range of up to 30 degrees and height adjustment of a further 50mm.
Our unique design has become extremely popular among the Adventure Rider community all around the world, helping riders transform their bikes!
The above picture shows :
a) Adjustable Brackets in powder coated black
b) 3/4 inch accessory bar
d) Rotating Baffle screen in powder coated black
Kit Configuration :
a) Adjustable Brackets (Available in stainless steel or powder coated black)
b) Accessory Bar
(Available in 1/2 inch or 3/4 inch diameter, stainless steel or powder coated black) 3/4 inch bars are bigger in diameter and provide more gripping surface for your gadgets.
c) Knobs (For easy adjustment of height and angle settings)
d) Baffle Screen (Available in stainless steel or powder coated black)
Other Benefits of this system also include:
To get you started, below are a few terminologies and their descriptions that you will see often in the kits :
- Accessory Bar - The Accessory Bar is designed to fit onto the Windshield Adapter Kit and also a stabilizing pole between the two adjustable brackets. It allows you to position your GPS/Phone/Accessory in the ideal position with minimum distraction from your view ahead. It also provides excellent weather protection for your accessories in this position. Made from 1/2" or 3/4" Diameter made from Stainless Steel or Black powder-coated alloy.
- Baffle Screen - The forward positioning of the screen is intended to help relieve air pressure built up in front of it. This means that some air does flow up between the screen and the cowl. In the colder months, this air may be unwanted so the screen baffle eliminates this and also offers additional protection from rain/snow, etc. The baffle is designed to rotate to any position you require and can also help fine-tune the elimination of turbulence and wind noise - especially useful if carrying luggage and/or passenger. There can be a slight increase in turbulence behind the screen at higher speeds with the gap totally blanked off. Made from Stainless Steel and available in a brushed-finish or Black Powder-Coated.
Screen Adapter Installation - Honda NC700X
The first step is to remove the bike's screen. Check the four rubber well-nuts are in good condition remain in their locations.
Mount the bracket assemblies as shown, using the new hardware provided. Before tightening the fasteners, check each set of brackets are parallel to each other. Please note: the picture above shows the optional 'tool-less' adjusters.
With the brackets mounted, install the screen using the new hardware provided. Check the holes in the screen line-up with the holes in the brackets - if there is any mis-alignment, make any necessary adjustments to the brackets angle or spacing to avoid placing any stress on the screen. Take care to ensure that the rubber washers are installed between the screen and the brackets. Do not over tighten the screen fasteners as this will cause stress which could lead to cracking - only tighten enough to lightly compress the rubber washers. Installation is now complete. Take care whilst riding to familiarize yourself with the bike's new characteristics and do not attempt to make adjustments whilst riding.